Microframe Corporation 3007 Series Uživatelská příručka stáhnout pdf (Strana 196)

2-14

Messages

BUTIL-47: BUTIL cannot open the command file

Ensure that the command file exists and that you specified the

command file location and filename correctly.

BUTIL-48: The command file is empty

Specify the desired commands in the command file before

attempting to use the command file again. In addition, ensure you

specified the correct command filename.

BUTIL-49: The command file exceeds 1,000 bytes

A command file cannot contain more than 1,000 bytes. Verify that

the command file adheres to this requirement.

BUTIL-50: An internal error caused BUTIL to terminate

The Maintenance utility detected an internal diagnostic error that

caused it to terminate.

BUTIL-52: MKDE cannot be stopped when SQL is loaded

Unload the MKDE before attempting to unload the MicroKernel.

BUTIL-53: MKDE error nn occurred for file or command

xxxx

The Maintenance utility returns a status code related to a particular

file or command. The corrective measure depends on the status code

received. Refer to Chapter 1, Status Codes for a description of Status

Code nn.

BUTIL-60: The end of the file occurred while BUTIL was

expecting keyword xxxx on key segment descriptor nn

Check the syntax of the description file.

BUTIL-61: The end of the file occurred while BUTIL was

expecting keyword xxxx

Check the syntax of the description file.

1 2 ... 191 192 193 194 195 196 197 198 199 200 201 ... 251 252

Žádné komentáře

Microframe Corporation 3007 Series Uživatelská příručka Strana 196