Microframe Corporation 3007 Series Uživatelská příručka stáhnout pdf (Strana 138)

1-130

Status Codes

Network Services Layer is still valid, but was dropped by the network.

Stop and restart the application.

3111: Failure during send to the target server

The Pervasive Network Services Layer attempted to send an

application request to the target server and encountered a network

specific error from the target. Check the Pervasive Event Log

(PVSW.LOG) for more information.

Note If there is a problem with AutoReconnect, a further status

code 3131 will be issued.

3112: Failure during receive from the target server

The Pervasive Network Services Layer attempted to receive data from

the target server and encountered a network specific error. Check the

Pervasive Event Log (PVSW.LOG) for more information.

Note If there is a problem with AutoReconnect, a further status

code 3131 will be issued.

You may also receive this error under the following circumstances:

 When using only the NetBIOS protocol with a remote

Workgroup engine, the client is sending more bytes than can fit

into the engine’s network read buffer. Go the machine where the

remote Workgroup engine is installed, and try increasing the

value of the configuration parameter, Server

Communication

Buffer Size

Read Buffer Size.

3114: The routing table of the Pervasive Network Services

Layer is full

The Pervasive Network Services Layer Server Routing Table is full.

This table normally grows dynamically as needed. Verify that you are

not in a low memory condition.

1 2 ... 133 134 135 136 137 138 139 140 141 142 143 ... 251 252

Žádné komentáře

Microframe Corporation 3007 Series Uživatelská příručka Strana 138