Microframe Corporation 3007 Series Uživatelská příručka stáhnout pdf (Strana 101)

1-93

1 to 199

These three values must have a 1:2:10 ratio. You can increase

these values to at most three times the default. If you

continue to receive this status code after increasing these

values, the problem is most likely not related to these

settings.

 For Windows servers, verify that the Maximum Packet Size

registry setting is 576 decimal or 240h. The path to the

MaxPktSize registry setting is

HKEY_LOCAL_MACHINE\System\currentControlSet\

Services\NwInkIPX\NetConfig\MaxPktSize.

If you continue to receive this status code after increasing the

network timeout parameters, this status code usually indicates a

problem with network communications. Verify that you have up

to date network cards and drivers; for example, incompatible

LAN card drivers can also cause this status code to occur.

Consult your LAN administrator for network communication

troubleshooting.

1 Choose StartRun.

2 Type Regedit and click OK. The Registry Editor opens.

3 Make the following CHANGES to the server’s registry using

Regedit:

HKEY_Local_Machine

SystemCurrentControlSetService

NwLnkIpx<Network Card>MaxPktSize = 240 Hex.

HKEY_Local_Machine

SystemCurrentControlSet |

Services

NwLnkIpx<Network Card>NetworkNumber =

<Non-Zero Value>

4 ADD the following registry entry:

HKEY_Local_Machine

SystemCurrentControlSet |

Services

LanManServerParametersMinClientBufferSize

regdword = 500 decimal.

96: A communications environment error occurred

The MicroKernel returns this status code for the following reasons:

 You tried to attach to the MicroKernel on a server, but the SPX

connection table or the MicroKernel client table is full. To avoid

receiving this error, add more memory. Both of these resources

are managed dynamically up to available memory.

1 2 ... 96 97 98 99 100 101 102 103 104 105 106 ... 251 252

Žádné komentáře

Microframe Corporation 3007 Series Uživatelská příručka Strana 101