Microframe Corporation 3007 Series Uživatelská příručka stáhnout pdf (Strana 195)

2-13

BUTIL

The internal overhead in bytes is as follows:

 Pre 8.x file format = 8

 8.x file format = 10 (4096 - 10 = 4086)

 9.0 file format = 10 (8192 - 10 = 8182)

 9.5 file format = 12 (16384 - 12 = 16372)

Note that it is advisable to leave some margin and not to use every

available byte because the amount of overhead may increase in

future file formats.

BUTIL-41: The alternate collating sequence cannot be

found

The Maintenance utility cannot find the alternate collating sequence

file you specified in the definition file. Verify that the alternate

collating sequence file exists and that the name is correct in the

definition file.

BUTIL-43: The file exists, but the Replace option was not

specified

The Maintenance utility did not create a file when you specified the

BUTIL –CREATE command because the file already exists. To

recreate this file, specify the Replace Existing File element in the

description file as Y.

BUTIL-44: The file access error nn occurred for file

filename

The Maintenance utility returns the appropriate status code and

filename for a file on which a file access error occurred during the

beginning or end of continuous operation. The corrective measure

depends on the status code received. Refer to Chapter 1, Status Codes

for a description of Status Code nn.

BUTIL-45: The number of duplicate keys must be between

1 and 119

Check the value specified for the Duplicate Key element in the

description file.

1 2 ... 190 191 192 193 194 195 196 197 198 199 200 ... 251 252

Žádné komentáře

Microframe Corporation 3007 Series Uživatelská příručka Strana 195